I had a scrap chunk of a carpenter saw that needed something done with it. I cut out a ulu shape and ground a chisel edge on it. For a handle there was a piece of lilac wood that has been laying around for several years. The bark was shaved off and a slit was cut into the bottom. Drilled in a couple 1/8'' holes through the wood and steel. The handle is pinned on with brass rod and copper burrs. I also used some epoxy. The epoxy was coloured up with a bit of powdered charcoal.
The blade was left as is from the saw. In my opinion this type of knife should be a wee bit soft. A pic is worth a thousand words so they say. thanks for looking.
http://i257.photobucket.com/albums/h...ps0dcaa5ac.jpg
