A few months ago I decided that I was due for another rifle. I had always wanted a .22 that could fire shorts as well as long rifle loads, but all I had were semi-autos. I was strolling through Walmart and noticed a Crickett rifle on the rack and only $117. I gave it the once over and decided that it would do the trick for what I wanted.
For those of you who aren't familiar with the Crickett rifles, they are a single shot, bolt-action rifle made as a beginner rifle for children. Overall, the rifle is 30" long and has a 16 1/4" barrel. It is equipped with a peep rear sight and a triangular front sight. As short as the rifle is, it handles very well for my adult frame.
As soon as I got home with the rifle, the wheels got to turning in my head. The rifle had the potential to be a pretty good camping/survival rifle. It fit right into the box that we keep our camping supplies in, so it would be easy to pack along.
My particular rifle came with a black synthetic stock with a removable buttplate. The stock is hollow, so I figured I didn't want that area to go to waste. I devised a small survival kit to go into the stock (contents will be listed later with the photo). The kit fit fine, but I ran into the problem of getting to it in an emergency. The buttplate was held on with phillips head screws. Now I almost always carry my Leatherman Wave with me, but I didn't want to have to rely solely on it. I got to looking around and found an old can opener/driver that I had taken off an old Swiss Army knife. I ground the tip of the driver at an angle similar to the phillips driver on a Leatherman Squirt. It worked great on the screws, plus I had a can opener.
Now, I had to attach the driver somehow, so I made a sling out of about 30' of paracord. I used the cobra stitch and put removable sling swivels on it. I wove the driver/can opener into the sling on the forend. Now all I have to do is remove the sling swivel on the forend and I can remove the buttplate screws. I also have plenty of paracord now.
This is a photo of the Crickett rifle with the sling attached.
http://i255.photobucket.com/albums/h...1/DSCN1170.jpg
Here is another photo of the sling:
http://i255.photobucket.com/albums/h...1/DSCN1171.jpg
Here is a closeup of the driver/can opener:
http://i255.photobucket.com/albums/h...1/DSCN1172.jpg
Here is the kit stuffed into the butt stock.
http://i255.photobucket.com/albums/h...1/DSCN1175.jpg
Here is the bag of kit removed from the butt stock.
http://i255.photobucket.com/albums/h...1/DSCN1178.jpg
Finally, the kit contents:
http://i255.photobucket.com/albums/h...1/DSCN1183.jpg
The contents are as follows (clockwise from top left):
1) Swedish firesteel with several feet of duct tape wrapped around the striker. 2) Wad of dryer lint for fire starting. 3) Sheet of aluminum foil. 4) Potable Aqua water purification tabs wrapped in aluminum foil. 5) fishing kit; (several feet of monofilament line wrapped around cardboard and a few hooks and sinkers). 6) Small compass. 7) razor blade (hey, it beats no cutting tool at all). 8) approximately 20-25 rounds of .22 ammo wrapped in bubble wrap. Mostly long rifle, but some shorts and a couple of birdshot rounds.
While this isn't the most ideal kit and rifle for a survival situation, I feel it is more than adequate to help out in a lot of situations that may arise, and takes up very little space.
I look forward to hearing your comments, although I will say that suggestions for additional kit items may not be considered, as this kit is a very tight squeeze as it is.

