If i haven't mentioned it;

the bow is 62" nock to nock.

the limbs taper in width from 1 7/16ths" at the fade, to 1 3/8" at midlimb down to 1/2" at the tips.

belly lam tapers in thickness from 3/8" just after the fades to 1/4" near the tips.

the 'boo backing is very thin, except towards the tips.

it draws 34lb at 20" and it's starting to make some audible complaints past that. it was tillered to 24" before i left it sitting for months in the work shop, so there is some concern, but then it might either be the bindings/epoxy making noise [no major concern] or the increase of belly compression and back tension between the bound areas [not so good].

because i am once again concerned about lamination failure, i'll hold off on draw pictures til i hand it to david. he should at least enjoy the experience of drawing it before it kerplodes [knock wood].