I just wanted to post a few knives I am working on. A work in progress just like me just ask my wife. This is a summarized version of what I do.
Here is how the knives are profiled as some of you guys know and do already.
Guests can not see images in the messages. Please register in the forum.
After the profile is ground out I scribe two lines in the center of the edge and grind a 45 degree starting bevel up to those lines. Athen start the flat grinds. This is what it ends up looking like.
Guests can not see images in the messages. Please register in the forum.
After the flat grind is done I measure for the pin hole placement.
Guests can not see images in the messages. Please register in the forum.
Here it is with the hole drilled
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Now I have drilled holes to remove steel and weight, so the blade will be more balanced.
Guests can not see images in the messages. Please register in the forum.
This is where I am at with these.I will add more pics as I progress. Thanks for looking.
Bookmarks