Results 1 to 2 of 2

Thread: I done shot my motor!!!!

  1. #1
    Tool & Die Maker
    Join Date
    Apr 2013
    Location
    Genoa, IL
    Posts
    456

    Default I done shot my motor!!!!

    Remember this:
    https://youtu.be/Ue3LxDRZ4Kw


    Didn't think this would happen but the moving target machine wasn't very level. The forward target was lower than the rear target. This made the forward target (the hogs) inline with the motor. Didn't realize I was pretty much shooting at the motor. Well, now the gearbox has a bullet hole in it so now it leaks oil. Fortunately the frame took most of the hits. The 22LR did minimal damage but the 223 was a different story. What I would like to do is mount a steel plate to the frame to shield the motor from further bullet hits. That little gear motor retails for $288 but fortunately I dug 3 of them out of the trash years ago. I think the gear motor will be ok used as it is as long as there isn't a fatal bullet strike. I'll post pictures later.

    I need to know how thick of a steel plate I need to not penetrate by a 223 round. Would 1/4" thick plate work?


  2. #2
    Administrator Rick's Avatar
    Join Date
    Nov 2007
    Location
    Central Indiana
    Posts
    56,572

    Default

    Set it on a slope and you can use thinner metal. \/ with the motor behind the V. That has the effect of increasing the thickness of the armoring plating.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •