Prototyping the TraumaSurgeon XL
A customer asked me about a longer, heavier set of spikes so I've come up with this so far, prototyping with some scrap aluminum (the hole is incidental):
Guests can not see images in the messages. Please register in the forum.
It is about 10" long will probably be made from 1/4 5160.
Last edited by crashdive123; 02-19-2015 at 09:33 PM.
Any sufficiently advanced incompetence is indistinguishable from malice - Grey's Law.
--------------------------------------------------------------------------------------------------------------------
To see what's going on in my knife shop check out CanidArmory on Youtube or on Facebook.
Looks like that could be a good neck knife. Kinda bird and trout knife looking.
When all else fails, read the directions, and beware the Chihuahuacabra!
Maybe I'll work up a smaller one in similar profile and see how that works. I have the first one of these well underway in 3/16" 1075 (since It's the thickest bar stock I have on hand at the moment). It's going to be a pretty hefty thrower in 1/4"
Any sufficiently advanced incompetence is indistinguishable from malice - Grey's Law.
--------------------------------------------------------------------------------------------------------------------
To see what's going on in my knife shop check out CanidArmory on Youtube or on Facebook.
Bird and Trout is a good description. Very nice job.
I like it a lot.
Posting Permissions
Reply With Quote
Bookmarks