You have finished a paracord project and are not sure what to do with the cord ends. Here are a couple of suggestions. Can be used with any number of strands.
Guests can not see images in the messages. Please register in the forum.
Method 1
First tie a crown knot https://www.google.com/?gws_rd=ssl#q=crown+knot
Guests can not see images in the messages. Please register in the forum.
then a wall knot https://www.google.com/?gws_rd=ssl#q=wall+knot
Guests can not see images in the messages. Please register in the forum.
Bring cord A under the 2 crossing strands a and repeat with the 3 remaining strands.
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Tighten. See last step in method 2.
Guests can not see images in the messages. Please register in the forum.
Method 2
Tie wall and crown knots as described above
Bring the wall knot strand parallel to the crown knot (you are doubling the crown knot here). Repeat with the 3 remaning strands.
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
With heamostat reach in through center of knot and grab the strand shown and pull strand through knot. Repeat with remaining strands.
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Tighten the knot. You can now trim the ends a short distance from the knot and sear them so that they do not fray OR cut the ends flush with the knot and by pushing the ends into the knot and moving the strands around you can make the ends disappear. The same goes true with method 1
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Bookmarks