The tutorials I have presented so far have been for diamond shape meshes. Sometimes square shape meshes are called for, for instance: tennis and volleyball nets. Here is how they are made.
Tie two meshes into a support loop. Leave a short tail (on left) to finish net.
Guests can not see images in the messages. Please register in the forum.
In the following rows tie into each mesh of the previous row until the desired width is met (measured from A to B)
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Net across without making the extra mesh
Guests can not see images in the messages. Please register in the forum.
Net across , tie the extra mesh and tie a colored yarn to remind you that you will be tying an extra loop each time you get to this side of the net.
Guests can not see images in the messages. Please register in the forum.
Net across and tie the last two meshes together. This forms the second corner of the net.
Guests can not see images in the messages. Please register in the forum.
Net across and tie the extra mesh (notice the reminder yarn).
Guests can not see images in the messages. Please register in the forum.
Net across - don't forget to tie the last two meshes together.
Guests can not see images in the messages. Please register in the forum.
When you get to the desired length - see A previous row tie two meshes together at the end of each row.
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Guests can not see images in the messages. Please register in the forum.
Tie the last two meshes together with a double sheet bend - no gauge
Guests can not see images in the messages. Please register in the forum.
This is a stock drawing of a double sheet bend.
Double Sheet Bend
Guests can not see images in the messages. Please register in the forum.
Untie the support loop and with the tail you left at the beinning tie the first two meshes together with the double sheet bend. trim the ends and you are done.
Bookmarks