OK, the saga continues,
I had ordered a new spring from Nurich,...looks just the the one that was in the gun.
Old spring appears that it had been cut, as there still is a sharp end on it.
New one, looks the same, but finer coils, and evened out at both ends....seems too short, wants to just fall out, and has a retaining pin on the bottom.....the old one doesn't.
So cleaned the whole thing out with break cleaner, and re-installed the old spring on the pin....but smooth end down...and it does have tension.(fit better than new assembly)
Gave it a try today, same thing, fires about 3 rounds then skips one or two, the fires and ships again.
Parts list shows an assembly with a metal top, and one with a plastic top....both of mine are plastic.....?
Ideas?
Reply With Quote
Bookmarks