I've been getting my shop put together as of late.
Figured I would post a few photos of some hardy hole tools I've made over the years.
thanks for looking
here's a post anvil made from a big splitting wedge. I hammered the end to a point and then ground it to fit the hardy hole. It's nice for hammering on knives. I've been grinding on it to true it up. Once true I'll polish the face.
Guests can not see images in the messages. Please register in the forum.
not a hardy hole tool but it's my hammer rack. Hardy hole tools are no good without a hammer LOL. I'm going to weld on some braces and such. Figured the braces would be nice to hang tongs on.
Guests can not see images in the messages. Please register in the forum.
a rough looking hot cut, it works.
Guests can not see images in the messages. Please register in the forum.
a fuller for hammering in grooves.
Guests can not see images in the messages. Please register in the forum.
not sure what to call this but it's made from a chunk of sch. 80 pipe cut in half long ways. there is a square shaft coming out the bottom that fits the hardy hole. Good for hammering in curves.
Guests can not see images in the messages. Please register in the forum.
I have a tool made from a trailer ball that fits the hardy hole. didn't get a photo of that one.
Bookmarks