Knife

[Runs With Beer]

Made this knife a few weeks ago. Cost $5.00 to make. Out of old forged chefs knife blade.

[crashdive123]

Truely a nice piece. Your talent shows. Good job.

[Runs With Beer]

Thanks Crash, See you Sat.

[nell67]

Very nice work RWB!

[crashdive123]

Thanks Crash, See you Sat.

Looking forward to it.

[Runs With Beer]

Thanks Nell, Im sendind your Fire kit out next week, Have been very busy.

[chiye tanka]

RWB that's a sweet piece of steel.

[Ole WV Coot]

I do admire a good lookin' blade and you done good.

[Runs With Beer]

Thank youSir.

[nell67]

Thanks Nell, Im sendind your Fire kit out next week, Have been very busy.

No worries:D

[Gray Wolf]

Very nice RWB.

[FVR]

I like both the knife and the rifle.

Do tell.

[Runs With Beer]

Thanks FVR, Its a 62cal. smoothbore from TVA.

[Blood Groove]

Hey I like that knife! The bone handle looks great, adn I love the distressed look of the steel. What kind of steel did you use?

[Riverrat]

Very nice, I have never worked with metal much, but when I get my shop up, well, I am going to have to try after seeing some off the knives you guys have built.....beauitful work.

[Runs With Beer]

I do make knives from scratch, But this one was a remake, Started out as an old fordged Chefs knife, I cliped the point, Cut the hand guard back, And put on a new grip. Took about 2 hours. Thanks for your comments.

[moses]

Very nice...

[backtobasics]

Made this knife a few weeks ago. Cost $5.00 to make. Out of old forged chefs knife blade.

Great looking knife. I've been wanting to do something just like that. I have the blade and the antler, but not sure what to do after that. How does a person get the antler to look that good, and what kind of epoxy do you use to hold it all together? This info would be great, Thanks MIKE

[Runs With Beer]

Thanks Mike, Iused 24 hour epoxy. Idrilled a hole in the antler and glued the blade in place. After its set over night I sanded the antler down till ti fits the blade. Hope this helps you.